Jenn-Air W27200, JJW9527, JJW8630, JJW8627, JJW8527, W3040OP, W30100, W30400, W27400, W27100, WW2460 Codes

resistance of the sensor increases. The resistance of the sensor at 350°F is approxi- mately 1654 ohms. The electronic control monitors the resistance value of the sensor and cycles the oven heating elements off. As the temperature in the oven decreases, the resistance of the sensor decreases. At a predetermined temperature setting, the electronic control will initiate another heat- ing cycle in the oven elements. See oven sensor chart at right for resistance values.

OVEN SENSOR

Sensor Type:	Calibration:
RTD 1000 ohm platinum 1654 ohms (350°E)
OVEN SENSOR RESISTANCE VS. TEMP. TABLE
Degrees E	Resistance
100	1143 ohms
200	1350 ohms
300	1553 ohms
350	1654 ohms
400	1753 ohms
500	1949 ohms
600	2142 ohms
700	2331 ohms
800	"2516 ohms
900	2697 ohms
1000	2874 ohms

FAULT CODES

There are built-in fault codes to assist the technician in diagnosis of the control system. Any time the control senses an error in the system, the control will beep at s 1 second interval until the ON/OFF key is pressed.

_u_	PROBLEM	COMPONENTS TO CHECK
CODES
	Oven Temperature	Ohm Test Sensor. Check connection at Sensor Wire
		Harness
F1

Shorted Key, Keyboard

Disconnected

Sensor Failure or Sensor

F3 Circuit Failure

Door Code

F9

Check control. If keyboard is not disconnected (F1-4) or key is not shorted (F1-3), replace control.

Ohm sensor. See chart,

Check Latch Assembly

For Models:

WW27110, WW30110, WM27160 (Oven Sensor Chart: Please refer to chart on 1-3)

16009721	COMPONENT DESCRIPTION	1-2
	O199g Maytag Appliances Sales Company