Oven Light
Bulb can be replaced or accessed by turning the lens counterclockwise to remove the
entire oven light. The socket can be removed by depressing the spring clips from the rear of the light socket end pushing it into the oven cavity.
A new oven light socket can be inserted and snapped into position by depressing the spring clips and reattaching in the original position.
Convection Motor Assembly
To access the motor assembly, remove the three 1/4" hex screws from the convect cover. Remove the cover. Remove three additional 1/4" hex screws that secure the convect motor assembly. Pull convect motor assembly into the oven cavity, dis- connecting the electricat
Reattach by returning to original position using reverse procedures.
OVEN VENT/SMOKE ELIMINATOR
,Remove oven vent and smoke eliminator by using tabs on bottom of smoke elimi- nator, turning counterclockwise to disen- gage the locking ears from the inner insulation retainer.
2.To remove the smoke eliminator, pull down end align locking ears with notches in oven cavity.
Reattach by reversing above procedures.
OVEN CAVITY
. All internal oven cavity components must be removed prior to oven cavity removal.
. Remove the five 1/4" hex screws from the front flange of the oven liner. (Three screws will be on the top and two on the bottom.)
3.Grasp the front flange of the oven liner and gently pull forward to remove oven liner from insulation and structure.
NOTE: When replacing oven cavity, use pieces of sheet metal on sides and top of oven liner to allow cavity installation without tearing or removing insulation.
When the cavity is within two inches of being in place, remove the sheet metal.
OVEN HINGE POCKETS
,Remove oven door following the steps previously described in section on Oven Door Removal.
. Remove hex screws from the lower front closure.
3.From each side of the range, remove two 1/4" hex screws.
4.Replace components and reassemble.
16009721 | COMPONENT ACCESS | |
| @1999 Maytag Appliances Sales Company |
|
