Mitsubishi Electronics QD75D, QD75P user manual Axis Same as error codes 515 to

15 TROUBLESHOOTING

MELSEC-Q

Related buffer memory				Set range
	address				Remedy
				(Setting with sequence program)
Axis 1	Axis 2	Axis 3	Axis 4

Same as error codes 515 to 516

• Correct the control system or parameter. (Refer to Section 9.1.6, 9.2.20)

• Do not make setting at buffer memory address 1906 (use prohibited area).

Correct the sub address (arc address). (Refer to Section 9.2.10)

<Positioning address/movement
amount>
• unit [mm] [pulse] [inch]
–2147483648 to 2147483647	Correct the end address (positioning address).
(Unit [degree]) cannot be set.
	(Refer to Section 9.2.10)
<Arc address>
–2147483648 to 2147483647

Refer to Section 5.3

"List of positioning data"

Correct the center point address (arc address). (Refer to Section 9.2.11)

Same as in error codes 504, 506.

Correct the positioning address. (Refer to Section 9.2.16, 9.2.17, 9.2.18)

Refer to Section 5.3

"List of positioning data" and Section 5.4 "Block start data"

—

In the error history, check the axis where the error other than this error occurred, and remove the error factor. Correct the block start data and positioning data.

15 - 19