Mitsubishi Electronics QD75D Axis 1 Axis 2 Axis 3 Axis 221 371 521, 225 375 525, 226 376 526

15 TROUBLESHOOTING

MELSEC-Q

Related buffer memory				Set range
	address				Remedy
				(Setting with sequence program)
Axis 1 Axis 2 Axis 3 Axis 4
71	221	371	521	0, 1
					With the setting brought into the setting range, turn the
72	222	372	522	• [mm] [inch] [pulse]	PLC READY signal [Y0] from OFF to ON.
73	223	373	523	–2147483648 to 2147483647
				• [degree] 0 to 35999999
74	224	374	524	1 to 1000000 [pulse/s]	• Bring the setting into the setting range.
					• Set the speed to the bias speed at start or higher.
75	225	375	525	1 to 2000000000 [mm/min or others]
					(Refer to Section 5.2.5)
					• Bring the setting into the setting range.
76	226	376	526	1 to 1000000 [pulse/s]	• Set the speed to that below the OPR speed.
77	227	377	527	1 to 2000000000 [mm/min or others] • Set the value to the bias speed at start or higher.
					(Refer to Section 5.2.5)
78	228	378	528	0, 1
79	229	379	529	0 to 65535
80	230	380	530	0 to 2147483647
81	231	381	531
82	232	382	532	0, 1, 2, 3
					With the setting brought into the setting range, turn the
83	233	383	533	0, 1, 2, 3
					PLC READY signal [Y0] from OFF to ON.
86	236	386	536	1 to 300
87	237	387	537	1 to 65535

88 238 388 538

0, 1

15 - 31