Mitsubishi Electronics QD75D Set the teaching data selection set value to within, Following cases

15 TROUBLESHOOTING

MELSEC-Q

Related buffer memory					Set range
	address					Remedy
				(Setting with sequence program)
Axis 1	Axis 2	Axis 3	Axis 4
For command speed,				1 to 1000000 [pulse/s]
refer to Section 5.3
				1 to 2000000000 [mm/min or another]
"List of positioning data"
Speed limit value				QD75P	:
				1 to 200000 [pulse/s]		Set the command speed to within the setting range.
				1 to 2000000000
10	160	310	460	[mm/min or another]
				QD75D	:
11	161	311	461	1 to 1000000 [pulse/s]
				1 to 2000000000
				[mm/min or another]
1549	1649	1749	1849	<Teaching positioning data No.>		Set the positioning data No. to within the setting range.
					1 to 600
1548	1648	1748	1848	<Teaching data selection>		Set the teaching data selection set value to within the
					0, 1	setting range.
						• Do not turn ON the target position change request in
						the following cases.
				<Target position change request		A control system other than ABS1, and INC1 is used.
						During deceleration stop. An operating pattern
1538	1638	1738	1838		flag>
						"continuous path control" is used.
				1: Target position change request
						• When the target position change address is outside
						the stroke limit, correct the target position change
						address. (Refer to Section 12.7.5)

15 - 37