Mitsubishi Electronics QD75P, QD75D Pinit, Device Setting data Setting range Setting side

14DEDICATED INSTRUCTIONS

14.7 PINIT

MELSEC-Q

This dedicated instruction is used to initialize the setting data of the QD75.

				Usable device
Setting	Internal device		File	MELSECNET/10		Special	Index	Constant
data				direct J	\	module	register		Others
			register
	Bit	Word		Bit	Word	U \G	Zn	K, H, $
(S)	–				–			–	–
(D)			–		–			–	–

[Instruction symbol] [Execution condition]

PINIT

Z.PINIT

"Un"

(S)

(D)

[Setting data]

Setting data	Setting details	Setting side	Data type
		( 1)
"Un"	QD75 head I/O number	User	BIN 16 bits
	(00 to FE: High-order two digits of I/O number expressed in three digits)
(S)	Head number of a device in which control data is stored	–	Device
	Head number of a bit device which turns ON the operation by one scan at the
(D)	time of completion of the instruction.	System	Bit
	If the instruction is completed abnormally, ((D) + 1) will also be turned ON.

Note) The file register of each of the local device and the program cannot be used as a device for setting data.

[Control data]

Device	Item		Setting data		Setting range	Setting side
						( 1)
(S)+0	System area		–		–	–
		The state at the time of completion is stored.
(S)+1	Complete status	0	: Normal completion		–	System
		Other than 0: Abnormal completion (error code)(		2)
1: The data on the setting side is as follows.
• User	: Data before the execution of dedicated instructions is stored by user.

•System: Data after the execution of dedicated instruction is stored by PLC CPU. 2: Refer to Section 15.2 for error codes at abnormal completion.

14 - 20