AT&T IPC-1600 manual MS-DOS Boot Error Message

MS-DOS Boot Error Message

The following error messages may be displayed at system boot time and can be caused by an incorrect board configuration.

SRAM MEMORY ERROR (Indicates faulty memory or memory not found.)

BIOS RESET ERROR (Indicates BIOS failed to initialize correctly.)

The following error messages may be displayed at system boot time and can be caused by a hardware problem.

FEPOS CODE MOVE ERROR (Indicates error when loading the on-board operating system.)

FEPOS INITIALIZATION ERROR (Indicates the on-board system failed to initialize.)

In response to these error messages, do the following.

■Check that the board parameters match the parameters specified by the IPC16CNF program.

■Try to reload the IPC16DOS.SYS driver.

■If the system still fails, recopy the driver from the “Intelligent Ports Card (IPC-1600) MS-DOS Device Drivers and Diagnostics, Version 1.0” diskette to the hard disk drive and try to reload the driver.

■Run the diagnostics.

■Call the AT&T HOTLINE at 1-800-922-0354 for help, as necessary.

7-2 IPC-1600 USER’S GUIDE