AT&T IPC-1600 manual Unix System Device Driver Installation

Installation Procedures

If you specify to share controller memory among all boards, you are then asked to select the controller memory starting address to be used by all IPC-1600 boards as follows. The IPC-1600 comes from the factory with the controller memory address range set to 080000h-08FFFFh. Remember to select a controller memory address range which does not conflict with other board types in the system.

The device driver used		for IPC-1600, Intelligent	Ports	Card
- Version 1.0	allows all the boards installed be strapped
to the same	controller	memory address. Please	select	the

controller memory address that will be used from the list below. The available controller memory address(es) for the

ports boards are:
Starting	Memory	address(s):
080000	(default)	090000	100000
180000		200000	280000
300000		380000	400000
480000		500000	580000
600000		680000	700000
780000		800000	880000
900000		980000	A00000
A80000		B00000	B80000
C00000		C80000	D00000
D80000		E00000	E80000
F00000		F80000

Type the starting controller memory address and strike the

ENTER key or type Q to cancel installation. Striking the ENTER alone will select the default:

UNIX SYSTEM DEVICE DRIVER INSTALLATION 3-9