Installation Information

Installing the 16-Ports Fanout Module

It is recommended that the upper position of the two mounting positions be used first to facilitate easy addition of the second 16-Ports Fanout module.

The 16-Ports Fanout module snaps into the wire-frame assembly from the front of the assembly (Figure C-2).First put the slot on the left side of the

16-Ports Fanout module over the wire tab on the left side of the wire-frame assembly. Then slide the right side of the 16-Ports Fanout module into the wire-frame assembly until the two slots on the right of the module engage the wire tabs.

Connecting Port Modular Cables

When connecting the modular cables to the 16-Ports Fanout module, it is important to label (identify) the circuit(s). The label information should include the port identification (ttyxyy) and the connecting device identification. After the modular cables are properly labeled (identified), connect each cable to the corresponding port and route the cable through the wiring guides. Be sure to connect the ground lead of the modular cable to the ground lug on the 16-Ports Fanout module.

C-4 IPC-1600 USER’S GUIDE

Page 149
Image 149
AT&T IPC-1600 manual Installing the 16-Ports Fanout Module, Connecting Port Modular Cables