AT&T IPC-1600 manual Finishing Up

Installation Procedure

Finishing Up

Quitting the IPC16CNF program using the Q)uit option produces various messages depending on what has been done before the exit request. During the exit process, a combination of the following prompts can be displayed.

R e - C o n f i g u r e t h e I P C 1 6 0 0 ( s ) ( Y / * ) :

Responding “Y” to this prompt causes the IPC-1600 to be reprogrammed. The system can then be used without a reboot. However, on the next reboot, the system will revert to the previous configuration unless the changes are saved to the system disk.

S a v e C h a n g e s t o D i s k f o r R e - B o o t ? ( Y / * ) :

Responding “Y” to this prompt changes the IPC16DOS.SYS file on the system disk to reflect the new configuration data. The new configuration is installed by rebooting the system. If the previous prompt was to “Re-Configure the IPC1600(s)” and the response was “Y”, the changes are currently in effect. However, on the next reboot, the system will revert to the previous configuration unless the changes are saved to the system disk.

Q u i t ? ( Q / * ) :

Responding “Q” to this prompt terminates the program returns to MS-DOS.

The following screen display shows the typical prompts after changing the IPC-1600 configuration options and quitting for the initial installation.

S a v e C h a n g e s t o D i s k f o r R e - B o o t ? ( Y / * ) : Y

Q u i t ? ( Q / * ) : Q

R e - b o o t t o L o a d D r i v e r

MS-DOS DEVICE DRIVER INSTALLATION 2-13