AT&T IPC-1600 manual Copy the files from the a drive to the C drive

Installation Procedure

Now, change directory (cd) to IPC and copy the files on the diskette in the “A” drive or in the “B” drive to the system disk drive as follows. The example uses the “A” diskette drive; the system disk is the “C” drive.

Change directory to an optional separate directory to contain the IPC-1600 software.

C:$ cd ipc

Copy the files from the “A” drive to the “C” drive

C:\IPC	$ copy a:*.* /v
A:IPC16CNF.EXE
A:IPC16DOS.SYS
A:IPC16DIA.COM
	3 F i l e ( s ) c o p i e d
C:\IPC	$

Remove the “Intelligent Ports Card (IPC-1600) MS-DOS Device Drivers and Dagnostics, Version 1.0” diskette from the diskette drive and properly store the diskette.

There are two files on the “Intelligent Ports Card (IPC-1600) MS-DOS Device Drivers and Diagnostics, Version 1.0” diskette concerned with the installation of the MS-DOS driver:

IPC16CNF.EXE Use this command to configure the Intelligent Ports Card driver characteristics.

IPC16DOS.SYS MS-DOS device driver for the IPC-1600.

The IPC16DIA.COM file provided on the MS-DOS diskette is the IPC-1600 diagnostics. Diagnostics are described in Chapter 7.

MS-DOS DEVICE DRIVER INSTALLATION 2-5