Zebra Technologies RW 420, RW 220 manual Installing RW Series Batteries, LI72 Charger, Charger Jack

Installing RW Series Batteries

Important • Batteries are shipped uncharged. Remove protective shrink-wrap and labels from new battery packs prior to use.

1.Rotate the Belt Clip to allow access to the Battery com- partment. This is an optional step on the RW 220.

2.Insert the battery into the printer as shown in Figure 3 or 4,

3.Rock the Battery into the printer as shown until it locks in place.

When the battery is first installed, the Control Panel indica- tors may briefly turn on and then go off, indicating the battery is not fully charged (see “Charging the Battery” below and “Operator Controls.”)

Figure 5: LI72 Single Charger

LI72 Charger

For best results, remove the Battery Pack while charging.

Charger Jack

The LI72 Charger

The LI72 is a wall mounted fast charger with universal 110 to 230, 50-60 Hz. VAC input. Multiple A.C. plug configurations comply with most international standards. This charger is in- tended for use with the RW series printers which are equipped with Lithium Ion (Li-ion) batteries.

continued

13

RW Series User Guide