Mitsubishi Electronics QD75D, QD75P Da.14 Parameter, Set the value as required for, Da.13

5DATA USED FOR POSITIONING CONTROL

Da.14 Parameter

MELSEC-Q

Set the value as required for "

Da.13

Special start instruction ".

		Special start instruction	Setting value	Setting details
	Da.13
Block start (Normal start)			–	Not used. (There is no need to set.)
Condition start				Set the condition data No. (No. of
				"condition data" set to perform
Wait start			1 to 10	condition judgment)
				(For details of the condition data, refer
Simultaneous start
				to Section 5.5.)
Repeated start (FOR loop)			0 to 255	Set the No. of repetitions.
				Set the condition data No. (No. of
				"condition data" set to perform
Repeated start (FOR condition)			1 to 10	condition judgment)
				(For details of the condition data, refer
				to Section 5.5.)

5 - 79