Jenn-Air WW27110, JJW9527 Oven Door Hinge Replacement, Cooling Fan Access, Oven Cavity Components

Models: JJW9530 JJW9630 JMW9527 JMW9530 JMW8527 JMW8530 WW30110 W2451 WM27460 WW27430P WM27260 WM27160 WW2460 WW27210 WW27430 WW27110 WW30430P WW30430 W27100 W27200 W27400 W30400 W30100 W3040OP JJW8527 JJW8627 JJW8630 JJW9527

1 51
Download 51 pages 32.56 Kb
Page 12
Image 12
OVEN DOOR HINGE REPLACEMENT

For JJW Models:

1.Lay oven door on a protected surface with the inner door panel facing down.

2.Remove the three screws at the top and the three at the bottom of the door, see Figure 2-2,

3.Grasp the door assembly at the bottom and lift the assembly off the front door glass.

4.Remove the two center screws holding the center bracket in position.

Figure 2-2

5.Once the center bracket is removed you will see two screws securing the trim to the glass. Remove these screws.

6.Remove the two screws holding the left and right side brackets in position.

7.Slide the front door glass out of the frame.

8.Reverse the procedure to reassemble.

OVEN DOOR HINGE REPLACEMENT

1.Remove two screws from oven inner door panel that mount into the lower portion of oven door hinge assembly.

2.Grasp and liftoven door hinge assembly upward and slide down to disengage upper tabs from the door panel.

3.To reassemble the oven door, reverse the procedures for disassembling.

COOLING FAN ACCESS

To access the cooling fan, remove two 1/4" hex screws from the bracket which the fan is mounted on. Tilt motor and bracket to allow it to pass through main back panel.

OVEN CAVITY COMPONENTS

Oven cavity components consist of: bake and broil elements, oven light assembly, convection motor, oven cavity, and oven sensor,

Oven Sensor Removal

Remove two 1/4" hex screws, pull oven sensor into oven cavity to gain access to the electrical quick connector.

To reassemble, use a probe and attach the probe to the quick connector, Guide it through the insulation to ensure the connec- tor does not contact the oven cavity. Contact could damage the connector.

Return to the original position, reattaching with the 1/4" hex screws.

Bake Element Removal

Remove the two 1/4" screws. Pull the bake element into the oven cavity to access electrical wiring.

Broil Element Removal

Remove the four 1/4" hex screws. Pull broil element into oven cavity to gain access to the electric wiring. Reattach by returning to the original position and fastening with four hex screws.

16009721

COMPONENT ACCESS

2-2

 

©1999 Maytag Appliances Sales Company

 

Page 12
Image 12
Jenn-Air WW27110, JJW9527, JJW8630, JJW8627, JJW8527 Oven Door Hinge Replacement, Cooling Fan Access, Oven Cavity Components