HP Manager Software manual „ ap port-list- List of MAP access ports to add to the group

set {ap dap} group 313

Defaults — None.

Access — Enabled.

History —Introduced in MSS 4.0.

Usage — MAPs are configured with an encryption key pair at the factory. The fingerprint for the public key is displayed on a label on the back of the MAP, in the following format:

RSA aaaa:aaaa:aaaa:aaaa: aaaa:aaaa:aaaa:aaaa

If a MAP is already installed and operating, you can use the display dap status command to display the fingerprint. The display dap config command lists a MAP’s fingerprint only if the fingerprint has been verified in MSS. If the fingerprint has not been verified, the fingerprint information in the command output is blank.

Examples — The following example verifies the fingerprint for

Distributed MAP 8:

WX-1200#set dap 8 fingerprint b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3

success: change accepted.

See Also

„set dap security on page 326

„display {ap dap} config on page 277

„display {ap dap} status on page 287

set {ap dap} group Configures a named group of MAP access points. MSS automatically load balances sessions among the access points in a group. To balance the sessions, MSS rejects an association request for an access point’s radio if that radio has at least four more active sessions than the radio of the same type with the least number of active sessions within the group.

Syntax — set {ap port-list dap (dap-num auto)} group name

„ap port-list— List of MAP access ports to add to the group.