HP Manager Software manual Set vlan port

110CHAPTER 5: VLAN COMMANDS

	VLAN names are case-sensitive for RADIUS authorization when a client
	roams to a wireless LAN switch. If the WX switch is not configured with
	the VLAN the client is on, but is configured with a VLAN that has the
	same spelling but different capitalization, authorization for the client fails.
	For example, if the client is on VLAN red but the WX switch to which the
	client roams has VLAN RED instead, RADIUS authorization fails.
	Examples — The following command assigns the name marigold to
	VLAN 3:
	WX4400# set vlan 3 name marigold
	success: change accepted.
	See Also
	„ set vlan port on page 110
set vlan port	Assigns one or more network ports to a VLAN. You also can add a virtual
	port to each network port by adding a tag value to the network port.
	Syntax — set vlan vlan-id port port-list [tag tag-value]
	„ vlan-id— VLAN name or number.
	„ port port-list— List of physical ports.
	„ tag tag-value— Tag value that identifies a virtual port. You can
	specify a value from 1 through 4095.
	By default, no ports are members of any VLANs. A wireless LAN switch
	cannot forward traffic on the network until you configure VLANs and add
	network ports to the VLANs.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Usage — You can combine this command with the set port name
	command to assign the name and add the ports at the same time.
	If you do not specify a tag value, the WX switch sends untagged frames
	for the VLAN. If you do specify a tag value, the WX sends tagged frames
	only for the VLAN.