HP Manager Software manual To 32 characters long, with no spaces or tabs

472CHAPTER 14: RADIUS AND SERVER GROUP COMMANDS

See Also

„clear radius proxy port on page 466

„set authentication proxy on page 238

„set radius proxy client on page 470

set radius server Configures RADIUS servers and their parameters. By default, the WX switch automatically sets all these values except the password (key).

Syntax — set radius server server-name

[address ip-address][auth-port port-number][acct-port port-number] [timeout seconds] [retransmit number] [deadtime minutes] [key string] [author-password password]

„server-name— Unique name for this RADIUS server. Enter an alphanumeric string of up to 32 characters, with no blanks.

„address ip-address— IP address of the RADIUS server. Enter the address in dotted decimal notation.

„auth-portport-number— UDP port that the WX switch uses for authentication and authorization.

„acct-portport-number — UDP port that the WX switch uses for accounting.

„timeout seconds — Number of seconds the WX switch waits for the RADIUS server to respond before retransmitting. You can specify from

1to 65,535 seconds.

„retransmit number — Number of transmission attempts made before declaring an unresponsive RADIUS server unavailable. You can specify from 1 to 100 retries.

„deadtime minutes — Number of minutes the WX switch waits after declaring an unresponsive RADIUS server unavailable before retrying that RADIUS server. Specify between 0 (zero) and 1440 minutes

(24 hours). A zero value causes the switch to identify unresponsive servers as available.

„key string — Password (shared secret key) the WX switch uses to authenticate to the RADIUS server. You must provide the same password that is defined on the RADIUS server. The password can be

1to 32 characters long, with no spaces or tabs.