HP Manager Software manual Syntax set service-profile Name auth-dot1x enable disable

set service-profile auth-dot1x 351

Defaults — WMM is enabled by default.

Access — Enabled.

History —Introduced in MSS Version 4.0.

Usage — When WMM is disabled, MAP forwarding prioritization is optimized for SpectraLink Voice Priority (SVP) instead of WMM, and the MAP does not tag packets it sends to the WX. Otherwise, classification and tagging remain in effect. (For information, see the “Wi-Fi Multimedia” chapter of the Wireless LAN Switch and Controller Configuration Guide.)

If you plan to use SVP or another non-WMM type of prioritization, you must configure ACLs to tag the packets. (See the “Enabling Prioritization for Legacy Voice over IP” section in the “Configuring and Managing Security ACLs” chapter of the Wireless LAN Switch and Controller Configuration Guide..)

Examples — The following command disables WMM in radio profile radprofsvp:

WX1200# set radio-profile radprofsvp wmm disable success: change accepted.

See Also

„set radio-profile mode on page 342

„display radio-profileon page 298

set service-profileDisables or reenables 802.1X authentication of Wi-Fi Protected Access

auth-dot1x(WPA) clients by MAP radios, when the WPA information element (IE) is enabled in the service profile that is mapped to the radio profile that the radios are using.

Syntax — set service-profile

name auth-dot1x {enable disable}

„name — Service profile name.

„enable — Enables 802.1X authentication of WPA clients.

„disable — Disables 802.1X authentication of WPA clients.