HP Manager Software manual Mode

342CHAPTER 9: MANAGED ACCESS POINT COMMANDS

See Also

„ display radio-profileon page 298

„ set radio-profile mode on page 342

„ set radio-profilemax-rx-lifetimeon page 340

set radio-profile	Creates a new radio profile, or disables or reenables all MAP radios that
mode	are using a specific profile.
	Syntax — set radio-profile name [mode {enable disable}]
	„	radio-profilename — Radio profile name of up to 16 alphanumeric
		characters, with no spaces.
		Use this command without the mode enable or mode disable
		option to create a new profile.
	„	mode enable — Enables the radios that use this profile.
	„	mode disable — Disables the radios that use this profile.

Defaults — Each radio profile that you create has a set of properties with factory default values that you can change with the other set radio-profilecommands in this chapter. Table 66 lists the parameters controlled by a radio profile and their default values.

Table 66 Defaults for Radio Profile Parameters

		Radio Behavior When Parameter Set to
Parameter	Default Value	Default Value
11g-only	disable	Allows associations with 802.11g and
		802.11b clients.
		Note: This parameter applies only to
		802.11b/g radios.
active-scan	enable	Sends probe any requests (probe requests
		with a null SSID name) to solicit probe
		responses from other access points.
auto-tune	enable	Allows dynamic configuration of channel
		and power settings by MSS.
beacon-interval	100	Waits 100 ms between beacons.
countermeasures	Not configured	Does not issue countermeasures against
		any device.