HP Manager Software manual Beacon-interval

336CHAPTER 9: MANAGED ACCESS POINT COMMANDS

	Examples — The following command sets the power interval for radios
	in radio profile rp2 to 240 seconds:
	WX4400# set radio-profile rp2 auto-tune power-interval 240
	success: change accepted.
	See Also
	„ set {ap dap} radio auto-tunemax-poweron page 317
	„ set {ap dap} radio auto-tune max- retransmissions on page 318
	„ set radio-profileauto-tunepower-backoff- timer on page 333
	„ set radio-profileauto-tunepower-configon page 334
set radio-profile	Changes the rate at which each MAP radio in a radio profile advertises its
beacon-interval	service set identifier (SSID).
	Syntax — set radio-profile name beacon-intervalinterval
	„ name — Radio profile name.
	„ interval — Number of milliseconds (ms) between beacons. You can
	specify from 25 ms to 8191 ms.
	Defaults — The beacon interval for MAP radios is 100 ms by default.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Usage — You must disable all radios that are using a radio profile before
	you can change parameters in the profile. Use the set radio-profile
	mode command.
	Examples — The following command changes the beacon interval for
	radio profile rp1 to 200 ms:
	WX4400# set radio-profile rp1 beacon-interval 200
	success: change accepted.

See Also

„display radio-profileon page 298

„set radio-profile mode on page 342