HP Manager Software manual Reset port, Set dap

	reset port 77
reset port	Resets a port by toggling its link state and Power over Ethernet (PoE)
	state.
	Syntax — reset port port-list
	„ port-list— List of physical ports. MSS resets all the specified ports.
	Defaults — None.
	Access — Enabled.
	History — Introduced in MSS Version 3.0.
	Usage — The reset command disables the port’s link and PoE (if
	applicable) for at least 1 second, then reenables them. This behavior is
	useful for forcing an MAP access point that is connected to two WX
	switches to reboot over the link to the other switch.
	Examples — The following command resets port 5:
	WX1200# reset port 5
	See Also
	„ set port on page 80
set dap	Configures a Distributed MAP for an MAP access point that is indirectly
	connected to the WX switch through an intermediate Layer 2 or Layer 3
	network.
	Before configuring a Distributed MAP, you must use the set
	system countrycode command to set the IEEE 802.11 country-specific
	regulations on the WX switch. See “set system countrycode” on page 54.
	For an MAP that is directly connected to the WX switch, use the set port
	type ap command to configure an MAP access port.
	Syntax — set dap dap-numserial-id serial-IDmodel
	{ap2750 ap3750 ap7250 ap8250 ap8750 mp-52 mp-101
	mp-122 mp-241 mp-252 mp-262 mp-341 mp-352}
	[radiotype {11a 11b 11g}]