HP Manager Software manual WX switch, Syntax help, „ Using CLI Help on

help 45

help	Displays a list of commands that can be used to configure and monitor
	the WX switch.
	Syntax — help
	Defaults — None.
	Access — All.
	History — Introduced in MSS Version 3.0.
	Examples — Use this command to see a list of available commands. If
	you have restricted access, you see fewer commands than if you have
	enabled access. To show a list of CLI commands available at the enabled
	access level, type the following command at the enabled access level:

WX4400# help Commands:

-------------------------------------------------------------------------

clear	Clear, use 'clear help' for more information
commit	Commit the content of the ACL table
copy	Copy from filename (or url) to filename (or url)
crypto	Crypto, use 'crypto help' for more information
delete	Delete url
dir	Show list of files on flash device
disable	Disable privileged mode
display	Display, use 'display help' for more information
exit	Exit from the Admin session
help	Show this help screen
history	Show contents of history substitution buffer
hit-sample-rate	Set NP hit-counter sample rate
load	Load, use 'load help' for more information
logout	Exit from the Admin session
monitor	Monitor, use 'monitor help' for more information
ping	Send echo packets to hosts
quit	Exit from the Admin session
reset	Reset, use 'reset help' for more information
rollback	Remove changes to the edited ACL table
save	Save the running configuration to persistent storage
set	Set, use 'set help' for more information
telnet	telnet IP address [server port]
traceroute	Print the route packets take to network host
	See Also
	„ “Using CLI Help” on page 31