HP Manager Software manual Set fdb, Adds a permanent or static entry to the forwarding database

set fdb 107

Table 24 Output for display vlan config (continued)

Field	Description
Tunl Affin	Tunnel affinity value assigned to the VLAN.
Port	Member port of the VLAN. The port can be a physical port or a
	virtual port.
	„ Physical ports are 10/100 Ethernet or gigabit Ethernet ports on
	the WX switch, and are listed by port number.
	„ Virtual ports are tunnels to other WX switches in a mobility
	domain, and are listed as follows: t:ip-addr, where ip-addris the
	system IP address of the WX switch at the other end of the
	tunnel.
	Note: This field can include MAP access ports and wired
	authentication ports, because MSS dynamically adds these ports to a
	VLAN when handling user traffic for the VLAN.
Tag	Tag value assigned to the port.
Port State	Link state of the port:
	„ Down — The port is not connected.
	„ Up — The port is connected.

See Also

„clear vlan on page 97

„set vlan name on page 109

„set vlan port on page 110

„set vlan tunnel-affinityon page 111

set fdb Adds a permanent or static entry to the forwarding database.

Syntax — set fdb {perm static}

mac-addr port port-list vlan vlan-id [tag tag-value]

„perm — Adds a permanent entry. A permanent entry does not age out and remains in the database even after a reboot, reset, or power cycle.

„static — Adds a static entry. A static entry does not age out, but is removed from the database after a reboot, reset, or power cycle.

„mac-addr— Destination MAC address of the entry. Use colons to separate the octets (for example, 00:11:22:aa:bb:cc).

„port port-list— List of physical destination ports for which to add the entry. A separate entry is added for each port you specify.