HP Manager Software Set ap dap radio mode, Enables or disables a radio on an MAP access point

set {ap dap} radio mode 323

set {ap dap} radio mode

Enables or disables a radio on an MAP access point.

Syntax — set {ap port-list dap {dap-num auto}}

radio {1 2} mode {enable disable}

„ap port-list— List of ports connected to the MAP access point(s) on which to turn a radio on or off.

„dap dap-num— Number of a Distributed MAP on which to turn a radio on or off.

„dap auto — Sets the radio mode for radios configured by the MAP configuration template. (See set dap auto on page 306.)

„radio 1 — Radio 1 of the MAP.

„radio 2 — Radio 2 of the MAP. (This option does not apply to single-radio models.)

„mode enable — Enables a radio.

„mode disable — Disables a radio.

Defaults — MAP access point radios are disabled by default.

Access — Enabled.

History —Introduced in MSS Version 3.0. MSS Version 4.0 added auto option for configuration of the MAP configuration template.

Usage — To enable or disable one or more radios to which a profile is assigned, use the set ap radio radio-profilecommand. To enable or disable all radios that use a specific radio profile, use the set radio-profilecommand.

Examples — The following command enables radio 1 on the MAP access points connected to ports 1 through 5:

WX1200# set ap 1-5 radio 1 mode enable success: change accepted.

The following command enables radio 2 on ports 1 through 3:

WX1200# set ap 1-3 radio 2 mode enable success: change accepted.