HP Manager Software manual Load config, Describes the fields in the display version output

load config 551

F/W1	: 4.2
F/W2	:	4.2
S/W	:	3.0.1_092304_WX1200

BOOT S/W : 3.0.1_082504

Table 105 describes the fields in the display version output.

Table 105 Output for display version

Field	Description
Build Information	Factory timestamp of the image file.
Label	Software version and build date.
Build Suffix	Build suffix.
Model	Build model.
Hardware	Version information for the WX switch’s motherboard and
	Power over Ethernet (PoE) board.
Serial number	Serial number of the WX switch.
Flash	Flash memory version.
Kernel	Kernel version.
BootLoader	Boot code version.
Port/DAP	Port number connected to an MAP access point.
AP Model	MAP model number.
Serial #	MAP serial number.
Versions	MAP hardware, firmware, and software versions.

	See Also
	„ display boot on page 547
load config	Loads configuration commands from a file and replaces the WX switch’s
	running configuration with the commands in the loaded file.
	CAUTION: This command completely removes the running configuration
	and replaces it with the configuration contained in the file. 3Com
	recommends that you save a copy of the current running configuration to
	a backup configuration file before loading a new configuration.