HP Manager Software Clear port type, „ display port preference on, „ set port preference on, Port

clear port type 65

	Examples — The following command clears the preference set on port 2
	on a WX4400 switch:
	WX4400# clear port preference 2
	See Also
	„ display port preference on page 69
	„ set port preference on page 85
clear port type	Removes all configuration settings from a port and resets the port as a
	network port.
	CAUTION: When you clear a port, MSS ends user sessions that are using
	the port.

Syntax — clear port type port-list

„port-list— List of physical ports. MSS resets and removes the configuration from all the specified ports.

Defaults — The cleared port becomes a network port but is not placed in any VLANs.

Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — Use this command to change a port back to a network port. All configuration settings specific to the port type are removed. For example, if you clear an MAP access point port, all MAP-specific settings are removed. Table 10 lists the default network port settings that MSS applies when you clear a port’s type.

Table 10 Network port defaults

Port Parameter	Setting
VLAN membership	None.
	Note: Although the command changes a port to a
	network port, the command does not place the port
	in any VLAN. To use the port in a VLAN, you must
	add the port to the VLAN.