HP Manager Software Set vlan, Tunnel-affinity, Adds ports 1 through 3 to the Vlan, To the port

set vlan tunnel-affinity 111

If you do specify a tag value, 3Com recommends that you use the same

	value as the VLAN number. MSS does not require the VLAN number and
	tag value to be the same but some other switches do.
	Examples — The following command assigns the name beige to VLAN
	11 and adds ports 1 through 3 to the VLAN:
	WX1200# set vlan 11 name beige port 1-3
	success: change accepted.
	The following command adds port 6 to VLAN beige and assigns tag value
	86 to the port:
	WX1200# set vlan beige port 6 tag 86
	success: change accepted.
	See Also
	„ clear vlan on page 97
	„ display vlan config on page 106
	„ set vlan name on page 109
set vlan	Changes a wireless LAN switch’s preferability within a mobility domain for
tunnel-affinity	tunneling user traffic for a VLAN. When a user roams to a WX switch that
	is not a member of the user’s VLAN, the WX can forward the user traffic
	by tunneling to another WX switch that is a member of the VLAN.

Syntax — set vlan vlan-idtunnel-affinity num

„vlan-id— VLAN name or number.

„num — Preference of this switch for forwarding user traffic for the VLAN. You can specify a value from 1 through 10. A higher number indicates a greater preference.

Defaults — Each VLAN on a WX switch’s network ports has an affinity value of 5 by default.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — Increasing a WX switch’s affinity value increases the WX’s preferability for forwarding user traffic for the VLAN.