HP Manager Software manual Set radio-profile, 11g-only

set radio-profile 11g-only 329

set radio-profile	Configures each 802.11b/g radio in a radio profile to allow associations
11g-only	with 802.11g clients only.
	Syntax — set radio-profile name 11g-only {enable disable}
	„ name — Radio profile name.
	„ enable — Configures radios to allow associations with 802.11g
	clients only.
	„ disable — Configures radios to allow associations with 802.11g
	clients and 802.11b clients.
	Defaults — The default setting is disable. 3Com 802.11b/g radios allow
	associations with 802.11g and 802.11b clients by default.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Usage — You must disable all radios that are using a radio profile before
	you can change parameters in the profile. Use the set radio-profile
	mode command.
	Even when association of 802.11b clients is disabled, if an 802.11b/g
	radio detects a beacon from an 802.11b network, the radio enters
	protection mode to guard against interference.
	The set radio-profile11g-onlycommand does not affect the radio
	support configured with the set port type ap command. For example, if
	you configure a radio to be 802.11b only when you set the port type, the
	set radio-profile 11g-only enable command does not enable 802.11g
	support on the radio.
	Examples — The following command configures the 802.11b/g radios in
	radio profile rp1 to allow associations from 802.11g clients only:
	WX4400# set radio-profile rp1 11g-only enable
	success: change accepted.

See Also

„display {ap dap} config on page 277

„display radio-profileon page 298

„set port type ap on page 87

„set radio-profile mode on page 342