HP Manager Software manual Set radio-profile auto-tune power-backoff- timer

set radio-profile auto-tune power-backoff- timer 333

Usage — 3Com recommends that you use an interval of at least 300 seconds (5 minutes).

RF Auto-Tuning can change a radio’s channel before the channel interval expires in response to RF anomalies. Even in this case, channel changes cannot occur more frequently than the channel holddown interval.

If you set the interval to 0, RF Auto-Tuning does not reevaluate the channel at regular intervals. However, RF Auto-Tuning can still change the channel in response to RF anomalies.

Examples — The following command sets the channel interval for radios in radio profile rp2 to 2700 seconds (45 minutes):

WX4400# set radio-profile rp2 auto-tunechannel-interval 2700 success: change accepted.

See Also

„set radio-profileauto-tunechannel-configon page 330

„set radio-profileauto-tunechannel-holddownon page 331

set radio-profile auto-tune power-backoff- timer

Sets the interval at which radios in a radio profile reduce power after temporarily increasing the power to maintain the minimum data rate for an associated client. At the end of each power-backoff interval, radios that temporarily increased their power reduce it by 1 dBm. The power backoff continues in 1 dBm increments after each interval until the power returns to expected setting.

Syntax — set radio-profile name auto-tune power-backoff-timer

seconds

„name — Radio profile name.

„seconds — Number of seconds radios wait before lowering the power by 1 dBm. You can specify from 0 to 65535 seconds.

Defaults — The default power-backoff interval is 10 seconds.

Access — Enabled.

History —Introduced in MSS Version 3.0.