HP Manager Software manual IP Services Commands

176CHAPTER 6: IP SERVICES COMMANDS

„To specify a passphrase, use the auth-pass-phrasestring option. The string can be from 8 to 32 alphanumeric characters long, with no spaces.

„To specify a key, use the auth-keyhex-stringoption.

„encrypt-type {none des 3des aes} {encrypt-pass-phrase string encrypt-key hex-string} —

Specifies the encryption type used for SNMP traffic. You can specify one of the following:

„none—No encryption is used. This is the default.

„des—Data Encryption Standard (DES) encryption is used.

„3des—Triple DES encryption is used.

„aes—Advanced Encryption Standard (AES) encryption is used.

If the encryption type is des, 3des, or aes, you can specify a passphrase or a hexadecimal key.

„To specify a passphrase, use the encrypt-pass-phrasestring option. The string can be from 8 to 32 alphanumeric characters long, with no spaces.

„To specify a key, use the encrypt-keyhex-stringoption.

Defaults — No SNMPv3 users are configured by default. When you configure an SNMPv3 user, the default access is read-only, and the default authentication and encryption types are both none.

Access — Enabled.

History —Introduced in MSS Version 4.0.

Examples — The following command creates USM user snmpmgr1, associated with the local SNMP engine ID. This user can send traps to notification receivers.

WX-1200# set snmp usm snmpmgr1 snmp-engine-id local success: change accepted.

The following command creates USM user securesnmpmgr1, which uses SHA authentication and 3DES encryption with passphrases. This user can send informs to the notification receiver that has engine ID 192.168.40.2.