326CHAPTER 9: MANAGED ACCESS POINT COMMANDS

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — You also can configure a radio’s channel on the same command line. Use the channel option.

This command is not valid if dynamic power tuning (RF Auto-Tuning) is enabled.

Examples — The following command configures the transmit power on the 802.11a radio on the MAP access point connected to port 5:

WX1200# set ap 5 radio 1 tx-power 10 success: change accepted.

The following command configures the channel and transmit power on the 802.11b/g radio on the MAP access point connected to port 1:

WX1200# set ap 1 radio 1 channel 1 tx-power 10 success: change accepted.

See Also

„“display {ap dap} config” on page 277

„set {ap dap} radio channel on page 320

set dap security Sets security requirements for management sessions between an WX switch and its Distributed MAPs.

This feature applies to Distributed MAPs only, not to directly connected MAPs configured on MAP access ports. In addition, MAP models AP7250, AP8250, AP8750, MAP-101 and MAP-122 do not have encryption keys and do not support this feature regardless of how they are connected to the WX switch.

The maximum transmission unit (MTU) for encrypted MAP management traffic is 1498 bytes, whereas the MTU for unencrypted management traffic is 1474 bytes. Make sure the devices in the intermediate network between the WX switch and Distributed MAP can support the higher MTU.

Syntax — set dap security {require none optional}