HP Manager Software manual Blink enable disable, Syntax set dap num fingerprint hex

312CHAPTER 9: MANAGED ACCESS POINT COMMANDS

Syntax — set {ap port-list dap (dap-num auto)}

blink {enable disable}

„ap port-list— List of ports connected to the MAP access points on which to turn blink mode on or off.

„dap dap-num— Number of a Distributed MAP on which to turn blink mode on or off.

„dap auto —Configures blink mode for the MAP configuration template. (See set dap auto on page 306.)

„enable — Enables blink mode.

„disable — Disables blink mode.

Defaults — LED blink mode is disabled by default.

Access — Enabled.

History —Introduced in MSS Version 3.0. Option auto added for configuration of the MAP configuration template in MSS Version 4.0.

Usage — Changing the LED blink mode does not alter operation of the

MAP access point. Only the behavior of the LEDs is affected.

Examples — The following command enables LED blink mode on the

MAP access points connected to ports 3 and 4:

WX1200# set ap 3-4 blink enable success: change accepted.

set dap fingerprint Verifies a MAP’s fingerprint on an WX switch. If MAP-WX security is required by a WX switch, a MAP can establish a management session with the switch only if you have verified the MAP’s identity by verifying its fingerprint on the switch.

Syntax — set dap num fingerprint hex

dap dap-num— Number of the Distributed MAP whose fingerprint you are verifying.

hex — The 16-digit hexadecimal number of the fingerprint. Use a colon between each digit. Make sure the fingerprint you enter matches the fingerprint used by the MAP.