HP Manager Software manual Set ap dap radio tx-power, Sets an MAP radio’s transmit power

set {ap dap} radio tx-power 325

Examples — The following command enables radio 1 on ports 3 through 6 assigned to radio profile rp1:

WX1200# set ap 3-6 radio 1 radio-profile rp1 mode enable success: change accepted.

See Also

„clear {ap dap} radio on page 272

„display radio-profileon page 298

„set {ap dap} radio mode on page 323

„set radio-profile mode on page 342

set {ap dap} radio tx-power

Sets an MAP radio’s transmit power.

Syntax — set {ap port-listdap dap-num}radio {1 2}

tx-powerpower-level

„ap port-list— List of ports connected to the MAP access points on which to set the transmit power.

„dap dap-num— Number of a Distributed MAP on which to set the transmit power.

„radio 1 — Radio 1 of the MAP.

„radio 2 — Radio 2 of the MAP. (This option does not apply to single-radio models.)

„tx-powerpower-level— Number of decibels in relation to 1 milliwatt (dBm). The valid values depend on the country of operation.

The maximum transmit power you can configure on any 3Com radio is the maximum allowed for the country in which you plan to operate the radio or one of the following values if that value is less than the country maximum: on an 802.11a radio, 11 dBm for channel numbers less than or equal to 64, or 10 dBm for channel numbers greater than 64; on an 802.11b/g radio, 16 dBm for all valid channel numbers for 802.11b, or 14 dBm for all valid channel numbers for 802.11g.

Defaults — The default transmit power on all MAP radio types is the highest setting allowed for the country of operation or highest setting supported on the hardware, whichever is lower.