HP Manager Software manual WX4400# set radio-profile rp1 mode enable

344CHAPTER 9: MANAGED ACCESS POINT COMMANDS

To change a parameter in a radio profile, you must first disable all the radios in the profile. After you complete the change, you can reenable the radios.

To enable or disable specific radios without disabling all of them, use the set ap radio command.

Examples — The following command configures a new radio profile named rp1:

WX4400# set radio-profile rp1 success: change accepted.

The following command enables the radios that use radio profile rp1:

WX4400# set radio-profile rp1 mode enable

The following commands disable the radios that use radio profile rp1, change the beacon interval, then reenable the radios:

WX4400# set radio-profile rp1 mode disable

WX4400# set radio-profile rp1 beacon-interval 200

WX4400# set radio-profile rp1 mode enable

The following command enables the WPA IE on MAP radios in radio profile rp2:

WX4400# set radio-profile rp2 wpa-ie enable success: change accepted.

See Also

„display {ap dap} config on page 277

„display radio-profileon page 298

„set {ap dap} radio mode on page 323

„set {ap dap} radio radio-profileon page 324