HP Manager Software manual Set radio-profile auto-tune power-interval

set radio-profile auto-tune power-interval 335

Examples — The following command enables dynamic power tuning for radios in the rp2 radio profile:

WX4400# set radio-profile rp2 auto-tunepower-config enable success: change accepted.

See Also

„set {ap dap} radio auto-tunemax-poweron page 317

„set {ap dap} radio auto-tune max- retransmissions on page 318

„set radio-profileauto-tunechannel-configon page 330

„set radio-profileauto-tunepower-backoff- timer on page 333

„set radio-profileauto-tunepower-intervalon page 335

set radio-profile auto-tune power-interval

Sets the interval at which RF Auto-Tuning decides whether to change the power level on radios in a radio profile. At the end of each interval, MSS processes the results of the RF scans performed during the previous interval, and changes radio power levels if needed.

Syntax — set radio-profile name auto-tune power-interval seconds

„name — Radio profile name.

„seconds — Number of seconds MSS waits before changing radio power levels to adjust to RF changes, if needed. You can specify from 1 to 65535 seconds.

Defaults — The default power tuning interval is 300 seconds.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — RF Auto-Tuning also can temporarily increase a radio’s power level to preserve the minimum data rate for an associated client. In this case, the radio reduces its power in 1 dBm increments until the power returns to the expected level.