HP Manager Software manual Set igmp rv

420CHAPTER 11: IGMP SNOOPING COMMANDS

	Defaults — By default, no ports are static multicast receiver ports.
	Access — Enabled.
	History — Introduced in MSS Version 3.0.
	Usage — You cannot add MAP access ports or wired authentication
	ports as static multicast ports. However, MSS can dynamically add these
	port types to the list of multicast ports based on multicast traffic.
	Examples — The following command adds port 7 as a static multicast
	receiver port:
	WX1200# set igmp receiver port 7 enable
	success: change accepted.
	The following command removes port 7 from the list of static multicast
	receiver ports:
	WX1200# set igmp receiver port 7 disable
	success: change accepted.
	See Also
	„ display igmp receiver-tableon page 407
set igmp rv	Changes the robustness value for one VLAN or all VLANs on a WX.
	Robustness adjusts the IGMP timers to the amount of traffic loss that
	occurs on the network.
	Syntax — set igmp rv num [vlan vlan-id]
	„ num — Robustness value. You can specify a value from 2 through 255.
	Set the robustness value higher to adjust for more traffic loss.
	„ vlan vlan-id— VLAN name or number. If you do not specify a
	VLAN, MSS changes the robustness value for all VLANs.
	Defaults — The default robustness value for all VLANs is 2.
	Access — Enabled.
	History — Introduced in MSS Version 3.0.