HP Manager Software Set snoop mode, To an MAP radio and enable the filter, All snoop filters

set snoop mode 575

See Also

„ clear snoop map on page 570 „ set snoop on page 571

„ set snoop mode on page 575

„ display snoop map on page 577 „ display snoop stats on page 578

set snoop mode	Enables a snoop filter. A snoop filter does not take effect until you map it
	to an MAP radio and enable the filter.
	set snoop {filter-nameall}
	mode {enable [stop-after num-pkts] disable}
	„	filter-nameall — Name of the snoop filter. Specify all to enable
		all snoop filters.
	„	enable [stop-afternum-pkts]— Enables the snoop filter.
		The stop-afteroption disables the filter after the specified number of

packets match the filter. Without the stop-afteroption, the filter operates until you disable it or until the MAP is restarted.

„ disable — Disables the snoop filter. Defaults — Snoop filters are disabled by default. Access — Enabled.

History —Introduced in MSS Version 4.0.

Usage — The filter mode is not retained if you change the filter configuration or disable and reenable the radio, or when the MAP or the WX switch is restarted. You must reenable the filter to place it back into effect.

Examples — The following command enables snoop filter snoop1, and configures the filter to stop after 5000 packets match the filter:

WX1200 set snoop snoop1 mode enable stop-after 5000 success: filter 'snoop1' enabled

See Also