HP Manager Software manual See Also, Syntax clear boot config

clear boot config 541

The backup command places the boot configuration file into the archive. (The boot configuration file is the Configured boot configuration in the display boot command’s output.) If the running configuration contains changes that have not been saved, these changes are not in the boot configuration file and are not archived. To make sure the archive contains the configuration that is currently running on the switch, use the

save config command to save the running configuration to the boot configuration file, before using the backup command.

Examples — The following command creates an archive of the system-critical files and copies the archive directly to a TFTP server. The filename in this example includes a TFTP server IP address, so the archive is not stored locally on the switch.

WX1200# backup system tftp:/10.10.20.9/sysa_bak critical success: sent 28263 bytes in 0.324 seconds [ 87231 bytes/sec]

See Also

„dir on page 545

„restore on page 555

clear boot config Resets to the factory default the configuration that MSS loads during a reboot.

Syntax — clear boot config

Defaults — None.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Examples — The following commands back up the configuration file on an WX switch, reset the switch to its factory default configuration, and reboot the switch:

WX4400# copy configuration tftp://10.1.1.1/backupcfg success: sent 365 bytes in 0.401 seconds [ 910 bytes/sec] WX4400# clear boot config

success: Reset boot config to factory defaults. WX4400# reset system force

...... rebooting ......