HP Manager Software manual Set ap dap radio auto-tune max-power

set {ap dap} radio auto-tune max-power 317

Usage — This command applies only to MAP models that support external antennas. External 802.11b/g antennas are supported on MAP-372, MAP-341, MAP-352, and MAP-262. External 802.11a antennas are supported only on model MAP-372. External dual-mode antennas are supported on AP2750, AP3750, AP7250, AP8250 and AP8750.

Examples — The following command configures the 802.11b/g radio on Distributed MAP 1 to use antenna model ANT1060:

WX4400# set dap 1 radio 1 antennatype ANT1060 success: change accepted.

See Also

„display {ap dap} config on page 277

set {ap dap} radio auto-tune max-power

Sets the maximum power that RF Auto-Tuning can set on a radio.

Syntax — set {ap port-list dap (dap-num auto)}

radio {1 2} auto-tune max-power power-level

„ap port-list— List of ports connected to the MAP access points on which to set the maximum power.

„dap dap-num— Number of a Distributed MAP on which to set the maximum power.

„dap auto — Sets the maximum power for radios configured by the MAP configuration template. (See set dap auto on page 306.)

„radio 1 — Radio 1 of the MAP.

„radio 2 — Radio 2 of the MAP. (This option does not apply to single-radio models.)

„power-level— Maximum power setting RF Auto-Tuning can assign to the radio, expressed as the number of decibels in relation to 1 milliwatt (dBm). You can specify a value from 1 up to the maximum value allowed for the country of operation.

The power-levelcan be a value from 1 to 20.

Defaults — The default maximum power setting that RF Auto-Tuning can set on a radio is the highest setting allowed for the country of operation or highest setting supported on the hardware, whichever is lower.