HP Manager Software manual Signature, WX switches in a Mobility Domain

532CHAPTER 17: RF DETECTION COMMANDS

set rfdetect	Enables MAP signatures. A MAP signature is a set of bits in a
signature	management frame sent by a MAP that identifies that MAP to MSS. If
	someone attempts to spoof management packets from a 3Com MAP,
	MSS can detect the spoof attempt.
	Syntax — set rfdetect signature {enable disable}
	„ enable — Enables MAP signatures.
	„ disable — Disables MAP signatures.
	Defaults — MAP signatures are disabled by default.
	Access — Enabled.
	History —Introduced in MSS Version 4.0.
	Usage — The command applies only to MAPs managed by the WX
	switch on which you enter the command. To enable signatures on all
	MAPs in a Mobility Domain, enter the command on each WX switch in
	the Mobility Domain.
	You must use the same MAP signature setting (enabled or disabled) on all
	WX switches in a Mobility Domain.
	Examples — The following command enables MAP signatures on an WX
	switch:
	WX1200# set rfdetect signature enable
	success: signature is now enabled.

set rfdetect ssid-listAdds an SSID to the permitted SSID list. The permitted SSID list specifies the SSIDs that are allowed on the network. If MSS detects packets for an SSID that is not on the list, the AP that sent the packets is classified as a rogue. MSS issues countermeasures against the rogue if they are enabled.

Syntax — set rfdetect ssid-list ssid-name

ssid-name— SSID name you want to add to the permitted SSID list.