HP Manager Software manual MAP Access Port Defaults

90CHAPTER 4: PORT COMMANDS

Table 17 MAP Access Port Defaults

Port Parameter	Setting
VLAN membership	Removed from all VLANs. You cannot assign an MAP
	access port to a VLAN. MSS automatically assigns MAP
	access ports to VLANs based on user traffic.
Spanning Tree Protocol	Not applicable
(STP)
802.1X	Uses authentication parameters configured for users.
Port groups	Not applicable
IGMP snooping	Enabled as users are authenticated and join VLANs.
Maximum user	Not applicable
sessions

This command does not apply to any gigabit Ethernet ports or to ports 7 and 8 on the WX1200 switch. To manage a MAP access point on a WX4400 switch, use the set dap command to configure a Distributed MAP connection on the switch.

Examples — The following command sets ports 1 through 3 and port 5 for MAP access point model AP3750 and enables PoE on the ports:

WX1200# set port type ap 1-3,5 model ap3750 poe enable

This may affect the power applied on the configured ports.

Would you like to continue? (y/n) [n]y

The following command sets ports 1 through 3 and port 5 for MAP access point model AP3750 and enables PoE on the ports:

WX1200# set port type ap 1-3,5 model ap3750 poe enable

This may affect the power applied on the configured ports.

Would you like to continue? (y/n) [n]y

The following command sets ports 1 through 3 and port 5 for MAP access point model AP8250 and enables PoE on the ports:

WX1200# set port type ap 1-3,5 model ap8250 poe enable

This may affect the power applied on the configured ports.

Would you like to continue? (y/n) [n]y

The following command sets ports 1 through 3 and port 5 for MAP access point model AP8750 and enables PoE on the ports:

WX1200# set port type ap 1-3,5 model ap8750 poe enable This may affect the power applied on the configured ports. Would you like to continue? (y/n) [n]y