HP Manager Software manual Corpvlan, Configures the MSS Dhcp server, Start ip-addr1 stop ip-addr2

set interface dhcp-server 145

	Examples — The following command enables the DHCP client on VLAN
	corpvlan:
	WX-1200#set interface corpvlan ip dhcp-client enable
	success: change accepted.
	See Also
	„ clear interface on page 115
	„ display dhcp-clienton page 182
	„ display interface on page 126
set interface	Configures the MSS DHCP server.
dhcp-server	Use of the MSS DHCP server to allocate client addresses is intended for
	temporary, demonstration deployments and not for production
	networks. 3Com recommends that you do not use the MSS DHCP server
	to allocate client addresses in a production network.
	Syntax — set interface vlan-idip dhcp-server [enable disable]
	[start ip-addr1 stop ip-addr2]
	„ vlan-id— VLAN name or number.
	„ enable — Enables the DHCP server.
	„ disable — Disables the DHCP server.
	„ start ip-addr1 — Specifies the beginning address of the address range
	(also called the address pool).
	„ stop ip-addr2 — Specifies the ending address of the address range.
	Defaults — The DHCP server is enabled by default on a new
	(unconfigured) WXR100 or WX1200, in order to provide an IP address to
	the host connected to the switch for access to the Web Quick Start. On
	all switch models, the DHCP server is enabled and cannot be disabled for
	directly connected MAPs.
	The DHCP server is disabled by default for any other use.
	Access — Enabled.
	History —Introduced in MSS Version 4.0.