HP Manager Software manual Display port

			display port preference 69
	Table 12 Output for display port poe
	Field	Description
	Port	Port number.
	Name	Port name. If the port does not have a name, the
		port number is listed.
	Link status	Link status of the port:
		„ up—The port is connected.
		„ down—The port is not connected.
	Port type	Port type:
		„ MAP —The port is an MAP access port.
		„ - (The port is not an MAP access port.)
	PoE config	PoE state:
		„	enabled
		„	disabled
	PoE Draw	Power draw on the port, in watts.
		For 10/100 Ethernet ports on which PoE is disabled,
		this field displays off. For gigabit Ethernet ports, this
		field displays invalid, because PoE is not supported
		on gigabit Ethernet ports.
		The value overcurrent indicates a PoE problem such
		as a short in the cable.
	See Also
	„ set port poe on page 84
display port	Displays the interface preferences set on WX4400 gigabit Ethernet ports.
preference	Syntax — display port preference [port-list]

„ port-list— List of physical ports. MSS displays the preference for all the specified ports.

Defaults — None.

Access — All.

History — Introduced in MSS Version 3.0.

Usage — This command applies only to the WX4400.