HP Manager Software manual Set snmp notify, Target, SNMPv3 with Informs

162CHAPTER 6: IP SERVICES COMMANDS

set snmp notify	Configures a notification target for informs from SNMP.
target	A notification target is a remote device to which MSS sends SNMP
	notifications. You can configure the MSS SNMP engine to send
	confirmed notifications (informs) or unconfirmed notifications (traps).
	Some of the command options differ depending on the SNMP version
	and the type of notification you specify. You can configure up to 10
	notification targets.
	SNMPv3 with Informs
	To configure a notification target for informs from SNMPv3, use the
	following command:
	Syntax — set snmp notify target target-num
	ip-addr[:udp-port-number]
	usm inform user username
	snmp-engine-id {ip hex hex-string}
	[profile profile-name]
	[security {unsecured authenticated encrypted}]
	[retries num]
	[timeout num]
	„ target-num— ID for the target. This ID is local to the WX switch and
	does not need to correspond to a value on the target itself. You can
	specify a number from 1 to 10.
	„ ip-addr[:udp-port-number]— IP address of the server. You also
	can specify the UDP port number to send notifications to.
	„ username — USM username. This option is applicable only when the
	SNMP version is usm.
	If the user will send informs rather than traps, you also must specify
	the snmp-engine-idof the target.
	„ snmp-engine-id {ip hex hex-string} — SNMP engine ID of the
	target. Specify ip if the target’s SNMP engine ID is based on its
	IP address. If the target’s SNMP engine ID is a hexadecimal value, use
	hex hex-stringto specify the value.
	„ profile profile-name— Notification profile this SNMP user will use
	to specify the notification types to send or drop.