HP Manager Software manual Set spantree, „ set spantree uplinkfast on

388CHAPTER 10: STP COMMANDS

Examples — The following command shows uplink fast convergence information for all VLANs:

WX4400# display spantree uplinkfast

VLAN port list

------------------------------------------------------------------------

1 1(fwd),2,3

Table 72 describes the fields in this display.

Table 72 Output for display spantree uplinkfast

Field	Description
VLAN	VLAN number.
port list	Ports in the uplink group. The port that is forwarding
	traffic is indicated by fwd. The other ports are blocking
	traffic.

	See Also
	„ set spantree uplinkfast on page 397
set spantree	Enables or disables STP on one VLAN or all VLANs configured on a WX
	switch.
	Syntax — set spantree {enable disable }
	[{all vlan vlan-id port port-list vlan-id}]
	„ enable — Enables STP.
	„ disable — Disables STP.
	„ all — Enables or disables STP on all VLANs.
	„ vlan vlan-id— VLAN name or number. MSS enables or disables STP
	on only the specified VLAN, on all ports within the VLAN.
	„ port port-listvlan-id— Port number or list and the VLAN the
	ports are in. MSS enables or disables STP on only the specified ports,
	within the specified VLAN.
	Defaults — Disabled.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.