HP Manager Software manual Priority, Uplinkfast

	set spantree priority 397
set spantree	Changes the STP root bridge priority of a wireless LAN switch on one or
priority	all of its VLANs.
	Syntax — set spantree priority value {all vlan vlan-id}
	„ priority value — Priority value. You can specify a value from 0
	through 65,535. The bridge with the lowest priority value is elected to
	be the root bridge for the spanning tree.
	„ all — Changes the bridge priority on all VLANs.
	„ vlan vlan-id— VLAN name or number. MSS changes the bridge
	priority on only the specified VLAN.
	Defaults — The default root bridge priority for the switch on all VLANs is
	32,768 for the WX4400 and 49,152 for the WX1200 and WXR100.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Examples — The following command sets the bridge priority of VLAN
	pink to 69:
	WX4400# set spantree priority 69 vlan pink
	success: change accepted.
	See Also
	„ display spantree on page 376
set spantree	Enables or disables STP uplink fast convergence on a wireless LAN switch.
uplinkfast	This feature enables a WX switch with redundant links to the network
	backbone to immediately switch to the backup link to the root bridge if
	the primary link fails.

Syntax — set spantree uplinkfast {enable disable}

„enable — Enables uplink fast convergence.

„disable — Disables uplink fast convergence.

Defaults — Disabled.

Access — Enabled.