HP Manager Software manual „ set timedate on „ set timezone on, Defaults „ count

140CHAPTER 6: IP SERVICES COMMANDS

„set timedate on page 180

„set timezone on page 181

ping	Tests IP connectivity between a wireless LAN switch and another device.
	MSS sends an Internet Control Message Protocol (ICMP) echo packet to
	the specified WX switch and listens for a reply packet.
	Syntax — ping host [count num-packets] [dnf] [flood]
	[interval time] [size size] [source-ipip-addr vlan-name]
	„ host — IP address, MAC address, hostname, alias, or user to ping.
	„ count num-packets— Number of ping packets to send. You can
	specify from 0 through 2,147,483,647. If you enter 0, MSS pings
	continuously until you interrupt the command.
	„ dnf — Enables the Do Not Fragment bit in the ping packet to prevent
	the packet from being fragmented.
	„ flood — Sends new ping packets as quickly as replies are received, or
	100 times per second, whichever is greater.
	Use the flood option sparingly. This option creates a lot of traffic and can
	affect other traffic on the network.
	„ interval time — Time interval between ping packets, in
	milliseconds. You can specify from 100 through 10,000.
	„ size size — Packet size, in bytes. You can specify from 56 through
	65,507.
	Because the WX switch adds header information, the ICMP packet size is
	8 bytes larger than the size you specify.
	„ source-ipip-addr— IP address, in dotted decimal notation, to use
	as the source IP address in the ping packets.
	„ source-ipvlan-name— VLAN name to use as the ping source. MSS
	uses the IP address configured on the VLAN as the source IP address in
	the ping packets.

Defaults

„count — 5.

„dnf — Disabled.

„interval — 100 (one tenth of a second)