HP Manager Software manual Set igmp qi, Syntax set igmp qi seconds vlan vlan-id

set igmp qi 417

set igmp qi	Changes the IGMP query interval timer on one VLAN or all VLANs on a
	WX.

Syntax — set igmp qi seconds [vlan vlan-id]

„qi seconds — Number of seconds that elapse between general queries sent by the WX when the WX switch is the querier for the subnet. You can specify a value from 1 through 65,535.

„vlan vlan-id— VLAN name or number. If you do not specify a VLAN, the timer change applies to all VLANs.

Defaults — The default query interval is 125 seconds.

Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — The query interval is applicable only when the WX is querier for the subnet. For the WX switch to become the querier, the pseudo-querier feature must be enabled on the WX and the WX must have the lowest IP address among all the WX switches eligible to become a querier. To enable the pseudo-querier feature, use the set igmp querier command.

Examples — The following command changes the query interval on

VLAN orange to 100 seconds:

WX1200# set igmp qi 100 vlan orange success: change accepted.

See Also

„set igmp lmqi on page 412

„set igmp oqi on page 415

„set igmp qri on page 418

„set igmp querier on page 419

„set igmp mrouter on page 413

„set igmp rv on page 420