HP Manager Software manual Visible, Display ap dap status command

526CHAPTER 17: RF DETECTION COMMANDS

Examples — The following example shows the permitted vendor list on

WX switch:

	WX1200# display rfdetect vendor-list
	Total number of entries: 1
		OUI	Type
	----------------- ------
	aa:bb:cc:00:00:00 client
	11:22:33:00:00:00 ap
	See Also
	„ clear rfdetect vendor-liston page 515
	„ set rfdetect vendor-liston page 533
display rfdetect	Displays the BSSIDs discovered by a specific 3Com radio. The data
visible	includes BSSIDs transmitted by other 3Com radios as well as by
	third-party access points.
	Syntax — display rfdetect visible mac-addr
	Syntax — display rfdetect visible ap map-num[radio {1 2}]
	Syntax — display rfdetect visible dap
		dap-num[radio {1 2}]
	„ mac-addr— Base MAC address of the 3Com radio.
		To display the base MAC address of a 3Com radio, use the
		display {ap dap} status command.
	„ map-num— Port connected to the MAP access point for which to
		display neighboring BSSIDs.
	„ dap-num— Number of a Distributed MAP for which to display
		neighboring BSSIDs.
	„	radio 1 — Shows neighbor information for radio 1.
	„	radio 2 — Shows neighbor information for radio 2. (This option does
		not apply to single-radio models.)

Defaults — None.

Access — Enabled.