HP Manager Software manual See Also „ display spantree portfast on

394CHAPTER 10: STP COMMANDS

See Also

„display spantree portfast on page 380

set spantree portpri Changes the STP priority of a network port or ports for selection as part of the path to the STP root bridge in the default VLAN on a wireless LAN switch.

Syntax — set spantree portpri port-listpriority value

„port-list— List of ports. MSS changes the priority on the specified ports.

„priority value — Priority value. You can specify a value from 0 (highest priority) through 255 (lowest priority).

Defaults — The default STP priority for all network ports is 128.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — This command applies only to the default VLAN (VLAN 1). To change the priority of a port in another VLAN, use the set spantree portvlanpri command.

Examples — The following command sets the priority of ports 3 and 4 to 48:

WX1200# set spantree portpri 3-4 priority 48 success: change accepted.

See Also

„clear spantree portpri on page 373

„clear spantree portvlanpri on page 374

„display spantree on page 376

„set spantree portvlanpri on page 396